Clean the gutters first, then hang the lights. A gutter packed with wet leaves and muck is heavy, it holds water, and it's the exact edge your clips are about to grip.
Why the order matters more than the lights do
Most people think of gutters and holiday lights as two separate chores. They're one job done in two passes, and the pass you do first decides how the second one goes.
By November a Gulf Coast gutter is holding oak leaves, pine needles, a summer of shingle grit, and a layer of wet mulch that never quite dried out. Rainy season ran May to October and the shaded runs never got a chance to drain. That load sits in the trough and pulls down on the hangers and fasteners that hold the gutter to the fascia.
Now you add clips and a strand of lights to that edge. You're asking a tired gutter to carry more, and you're pressing the clips onto a lip that's coated in grime. Clips grip clean metal. They slide on slime.
That's the whole case for cleaning first. Do this job before the other one.
What a packed gutter does to a strand of lights
Three things go wrong, and you'll recognize the first one fast.
- The gutter sags. A full trough pulls away from the fascia, and a strand clipped along it sags with it. The lights that looked straight on the ladder look like a smile on the lawn.
- The lights sit in water. A gutter that can't drain holds a standing pool right under the clips. Cords and plugs lying in it is the thing you don't want, so keep every connection out of standing water.
- The clips let go. A clip on a slick, dirty lip walks off in the first stiff breeze or the first afternoon downpour, and you're back up the ladder in the dark.
None of that needs a number to understand. A heavy, wet, slippery edge is a bad place to hang anything.
The black stripes show up under the lights
This is the one that bothers people most, and it's the one nobody warns you about. Look at the face of your gutter, the flat front that faces the street. On most houses here it's streaked with long vertical black lines.
Those stripes are runoff residue and growth that wash down the gutter face every time it rains. They're easy to ignore at noon. Under a strand of warm white lights at night, they're the first thing the eye lands on, and they show in every photo you take of the house.
You can hang beautiful lights on a dirty line and the line still reads dirty. The lights don't hide it. They light it up.
That's also why the face of the gutter is part of this job along with the inside of the trough. If the streaks are heavy, a gentle wash of the face and the fascia behind it is what makes the roofline look finished. Our house washing covers the walls, soffit and fascia at pressure the material can take.
The order to do it in before the lights go up
Work top to bottom, inside to outside, and don't hang a single clip until the last step is done.
- Pull the debris out. Scoop the loose leaves and packed muck out of every run, working toward the downspout. Bag it. Don't flush it into the yard bed.
- Flush each run with water. Run a hose from the far end toward the downspout and watch it. Water should move steadily and leave the downspout clean. If it backs up, the downspout is clogged, not the gutter.
- Wash the face. Clean the front of the gutter and the fascia so the black stripes are gone before anything is clipped to them.
- Check the lip and the hangers. Look for a section that sags, a hanger that's pulled loose, or a seam that drips. Fix or flag it now, while there's nothing on it.
- Let it dry, then hang. Clips go on a clean, dry lip. Start from the outlet end, and keep every plug and connection up off the gutter floor and out of any water.
If you do step four after the lights are up, you're taking the lights down to fix a hanger. Do it in order and you only climb once.
Why a Gulf Coast roofline gets worse than most
Shade is the main reason. A gutter under an oak canopy stays damp, and damp is where the growth and the muck live. The north and east sides of the house are usually the worst. We wrote about why the shady side is always the worst side, and the gutter line follows the same rule.
And the timing is tight. The rainy season just ended, so the debris is fresh and wet, and the lights go up in the next few weeks. That's the window where a clean line matters most and gets skipped most.
Why hanging first backfires
Hanging first and planning to clean later doesn't work. Once the strand is clipped on, you can't get a scoop or a hose down the run without unclipping it.
Blasting the gutter face with a pressure washer doesn't work either. High pressure on a thin aluminum gutter dents it and drives water behind the fascia. The face wants a gentle wash, the same low pressure approach we use on a roof, not a hard spray.
Flushing the muck out with the hose and no scoop first doesn't work. You just wash the packed debris into the downspout and plug it, and now the water has nowhere to go.
When a pro visit pays for itself before the holidays
Some houses are a Saturday morning with a hose and a scoop. Others aren't, and you'll know which one yours is.
Bring someone in if the gutters sit on a second story and you don't want to be on a ladder at that height with wet hands. Bring someone in if the runs are packed solid and the downspouts won't flush. And bring someone in if the black streaks on the face are heavy enough that a hose won't touch them.
A visit that fits your timeline looks like this. We clear the runs, flush them to the downspout, and wash the face. We tell you straight if a hanger is loose or a seam is leaking, so you can sort that out before the lights go on. Then you hang your lights on a clean line in one pass.
If you want the gutters done and the lights still going up on schedule, book it early. Cleaning before the storm instead of after is the same logic. The work goes faster when there's nothing on the line yet. You can see what our gutter cleaning covers on the service page.
Common questions
Should I clean my gutters before hanging Christmas lights?
Yes. Clean first, then hang. Debris makes a gutter heavy and holds water, and clips grip a clean lip far better than a dirty one. It's also a lot easier to scoop and flush a run before a strand is clipped along it.
Can I hang Christmas lights on gutters that are full of leaves?
You can, but you'll regret it. A full gutter sags, so the strand sags with it. It also holds standing water right where the clips and cords sit. Clear it out first, and keep every plug and connection out of any water that's left.
What's the best way to attach lights to a gutter?
Use clips made for the job, and put them on a clean, dry lip so they hold. Start at the outlet end and work away from it. Check the hangers before you start, because a gutter that's already pulling loose won't improve under a strand of lights.
Get the gutter line done before the lights go up
Mr. Pressure Cleaning is a family owned crew out of North Port, and Matt Rice owns it and answers his own phone. Call or text (941) 257-8624, Mon to Sat, 8am to 7pm. We quote every job free by text or over the phone, with no site visit needed for a number. Send a photo of the roofline and tell us when the lights are going up.