House Washing
Whole exterior soft wash at 900 to 1200 PSI. Stucco, siding, soffit, fascia and the outside of your gutters, with the chemical diluted down after the rinse.
See House Washing
Pool Cage and Deck Cleaning in Port Charlotte, FL
Screen enclosure and the deck under it, cleaned at 900 to 1200 PSI soft wash pressure so the screens and frames are not damaged.
Who handles pool cage and deck cleaning in Port Charlotte, FL?
Port Charlotte cage screens, frames and decks cleaned at 900 to 1200 PSI. New screen and original frames. Mr. Pressure Cleaning has worked Charlotte County for over a decade, out of North Port. Estimates are free and quoted online, by text or over the phone, never in person. Call (941) 257-8624.
Port Charlotte, FL
What does pool cage and deck cleaning in Port Charlotte involve?
A lot of Port Charlotte enclosures are wearing new screen on an original frame. The 2022 storm went through the cages before it went through anything else, and rescreening was the common repair, so a very ordinary sight on this grid is bright mesh stretched across aluminium that has been standing since the house was built. Owners reasonably assume the new screen buys them years. It does not. New mesh films at exactly the same rate as old mesh, it just starts from a cleaner baseline, so the change creeps up instead of arriving.
The whole enclosure gets 900 to 1200 PSI. Screens, aluminium frames and rails, and the deck under them, concrete or brick pavers, as one job. That is soft wash pressure, the same range that goes on a house exterior. It lifts what the mix has already killed and leaves mesh sitting in its splines. The 3000 to 4000 PSI that cleans the driveway out front never gets pointed at a screen, and that distinction is precisely how screens get torn by people who do not make it.
- Screens, aluminium frames and the deck under them, one job
- Cleaned at 900 to 1200 PSI soft wash pressure, never high pressure
- The green film that makes a pool deck slippery washed off
- Surfactant based mixes matched to the surface, so chemistry does the work
- Chemical diluted down after until it stops acting on anything
- Free estimates by text, phone or online
New Screen on an Old Frame
The mismatch is worth understanding because it changes what you should expect from a clean. Rescreened panels come back to something close to new. The original frame they are hung on does not, because decades of Gulf weather oxidise an aluminium finish and oxidation is not dirt. What does come off the frame is the growth and the water staining that runs down from the top rail, and on most of these enclosures that is the bulk of what you are actually looking at. You will get told which is which from photos, before anything is scheduled, rather than discovering it on the day.
The view panel is the one that matters most and gets mentioned least. On the canal lots through South Gulf Cove, El Jobean, Edgewater and Grassy Point, one wall of the cage is pointed at the water and that panel is the reason the house cost what it cost. Mesh loses clarity long before it shows any colour, so the view goes soft by degrees and the owner adapts to it without ever deciding to. Cleaning that panel is the single change people react to hardest, and it is a bigger visual difference than anything that happens to the deck.
Underneath, the deck is the half that is not about appearance. Pavers and concrete around a pool are wet more often than any other hard surface on the property, and what grows on them in shade is what makes them slick. It arrives gradually and never looks alarming, which is why it surprises people. The deck is cleaned as part of the enclosure at the same 900 to 1200 PSI rather than quoted separately, because doing the screens over a slick deck fixes the half you look at and none of the half you stand on.
- Rescreened panels and original frames, both at 900 to 1200 PSI
- The view panel facing the canal, where lost clarity is the real complaint
- Water staining running down from the top rail and the corner posts
- Pavers and concrete under the cage, where the slip risk lives
- Canal lots at South Gulf Cove, El Jobean, Edgewater and Grassy Point
- A clear split, from photos, between what cleans and what has oxidised
Areas of Port Charlotte we work in
Section 15, Murdock, South Gulf Cove, El Jobean, Riverwood, Heritage Oak Park, Grassy Point, Edgewater.
Why Your Screens Never See High Pressure
The question everyone asks first: will it tear my screens? Not at the pressure we use. Screens and frames get 900 to 1200 PSI, and that number is the answer. Enough to lift the algae, gentle enough to leave the mesh and the frame alone.
Every surface we clean gets its own pressure. Roofs get a maximum of 70 PSI from a battery pump. Concrete gets 3000 to 4000 PSI, because concrete is built for it. A screen is not concrete, so it never gets concrete's pressure. Getting that judgement right, surface by surface, is the job you're actually hiring.
What Gets Cleaned
The whole enclosure, not just the panels you look through. A cage that's clean at eye level and green overhead still reads dirty every time the sun comes through it.
Screens, frame and deck get quoted together as one job, online, by text or over the phone. Residential and commercial.
- Screen panels, walls and overhead
- Aluminium frames and rails
- The pool deck under it all, concrete or brick pavers
Grey Screens Are Usually Dirt, Not Age
Screen mesh fogs over with the same growth that streaks roofs here. Some of that grey is dirt and algae, and it washes off. Some of it is age, and no wash turns old mesh new.
You get a straight answer about which one you've got. Send Matt a photo of the enclosure and he'll tell you what cleaning will fix and what it won't, before you've committed to anything.
The Deck Is Half the Job
The deck under a cage collects the same growth as the screens, and down there it's a slip problem, not just a grey one. The film that turns a pool deck green is the same film that makes it slick when it's wet, and around a pool it's always wet somewhere.
Screens, frames and deck get cleaned as one job, whether the deck is concrete or brick pavers. A bright cage over a green deck is half a job, so we don't do halves.
The Cleaning Is Chemistry, Not Force
At soft wash pressure, the cleaning power comes from the mix, not the machine. We use surfactant based soap and degreaser mixes matched to each surface, so the growth lets go without the pressure doing damage.
Then the part that matters most. Pool cages sit in the middle of the landscaping, with planting beds right against the frame. We remove the chemical by diluting it down so far it stops acting on anything. Dilution is the solution. If you have irrigation around the cage, run it before we arrive and for at least a week to 10 days after we leave, so nothing dies at the root. That's the step we lead with, because losing the landscaping is the fear that actually stops people booking.
When People Call About a Cage
These are the calls that usually come in:
Whichever one is yours, it starts the same way. Send Matt a photo of the enclosure, or call, and he tells you what it needs. Free.
- Screens gone grey or green
- Streaks running down the aluminium frame
- A deck that's slick underfoot
- Company coming and the lanai looks tired
- Getting the house ready to list
Why People Call Mr. Pressure Cleaning
Matt answers his own phone, and he shows up when he says he will. The person quoting your cage is the person cleaning it.
Family owned and operated out of North Port, working the Gulf Coast for over a decade. If it's black or green, we will make it clean.
- Family owned, licensed and insured
- Over a decade on the Gulf Coast
- Matt answers his own phone
- Free estimates by text, phone or online
- 4.7 stars from 58 Google reviews
Straight Answers
What people ask about pool cage & deck in Port Charlotte
Will pressure washing tear my pool screens?
Not at the pressure we use. Screens and frames get 900 to 1200 PSI, soft wash pressure, the same range we use on soffit and fascia. The 3000 to 4000 PSI that cleans a driveway never gets pointed at mesh. The pressure is matched to the surface on every job, and screens are the clearest case there is.
My screens are old. Can you still clean them?
Usually, because soft wash pressure is gentle by design. But old mesh is old mesh, and nobody should promise otherwise without seeing it. Send Matt a photo of the enclosure and he'll tell you straight what cleaning will fix, and whether any panel is too far gone to touch.
Do you clean the deck too, or just the screens?
Both, as one job. Screens, frames and the deck under them, concrete or brick pavers. The deck is where the slip risk lives, so leaving it out would miss the point.
Will the chemicals hurt the plants around my cage?
This is the step we lead with. The mix is matched to the surface, then removed by diluting it down so far it stops acting on anything. Dilution is the solution. If you have irrigation around the cage, run it before we arrive and for a week to 10 days after we leave. Losing the landscaping is the fear that stops most people booking, and this is the answer to it.
How often does a pool cage need cleaning?
Results typically stay clean about a year. Same heat, same humidity, so the growth comes back eventually. When the screens start going grey again, that's the time to call.
What does pool cage cleaning cost?
Every job is quoted free, online, by text or over the phone. Cage size, deck size and how far the growth has gone all move the number, so send a photo or two and Matt gives you a straight answer back. No waiting on an appointment window. No obligation.
The screen was replaced three years ago and it already looks dull. Was it done badly?
Almost certainly not. New mesh collects the same film as old mesh at the same rate, it simply starts from a clearer baseline so you notice the loss rather than the state. Three years of Port Charlotte humidity on a cage is a normal amount of build up. A wash at 900 to 1200 PSI takes it back off. If any panel genuinely was not installed right, you will hear that too, but a dull screen at three years is the climate rather than the installer.
The frame is chalky and white in places. Will washing bring it back?
The staining will come off. The chalkiness will not, because that is the finish on the aluminium oxidising rather than anything sitting on top of it, and no wash reverses it. On a lot of original frames around here the two are mixed together, which is why it is worth sending photos first. Matt will tell you what proportion of what you are seeing is going to lift, so you know what you are buying before you agree to it.
Can the cage be done at the same time as the roof?
Yes, and the order matters. The roof goes first, because everything that comes off a roof lands on whatever is underneath it, and the cage below gets cleaned after. Two surfaces, two pressures, a maximum of 70 PSI up top and 900 to 1200 PSI on the enclosure, one visit and one free quote. Send photos of both and it gets priced together.
Pool Cage & Deck Nearby
Based in North Port, working roughly 50 miles either side of I-75. Same services, same Florida weather, in every town on the list.
One Call Covers It
Related Services
Driveway and Paver Cleaning
Concrete, brick pavers, sidewalks and curbing cleaned at 3000 to 4000 PSI. Hard surfaces only, where real pressure is the right tool.
See Driveway & Pavers Roof Cleaning
Soft wash roof cleaning for shingle, tile and metal at a maximum of 70 PSI. Streaks and growth come off without putting high pressure on your roof components.
See Roof CleaningNeed pool cage & deck in Port Charlotte?
Free estimates, no obligation. Send a photo and get a real number back, online, by text or over the phone.